Operating Procedures of 808nm Diode Laser Hair Removal

2021-08-27 11:31:16

Operating Procedures of 808nm
Diode Laser Hair Removal

　　①Add water to the machine first (the water filling hole and overflow hole on the back of the chassis, use the equipped funnel to add water, open the overflow hole when adding water, and add water until there is water in the overflow hole, which means that the water is enough) The 808nm freezing point hair removal instrument has requirements for water quality. It is recommended to use distilled water and purified water instead of tap water or mineral water. It is better to use deionized water if possible;

　　②Connect the power cord, please check the input part, and it can not be connected wrongly;

　　③Turn on the air switch;

　　④Turn on the key switch;

　　Notes on use

　　①Keep the water tank adequate and clean. It is recommended to change the water once a month

　　②The room temperature is controlled at 5℃～28℃. If you must work in an air-conditioned room in summer, prevent the water temperature from being too high; if in winter, prevent the water from freezing;

　　③It is recommended to use a handle collar to prevent the handle from falling;

　　The hair growth cycle has three phases: growth phase, degeneration phase, and resting phase.

　　The effect that can only be achieved by 808 freezing point hair removal during the growth period. During the growth period, the pigment particles produced inside can completely absorb the heat energy. At this time, the hair is fragile, and the effect of hair removal must be. It is also related to the area's hair density, color, and non-growth ratio. Generally, you can see obvious results once or twice.